Bill Calfee
Gun Fool
Been working on my 40-X pistol......
CYA friends:
I've been working on my 40-X pistol some today...
I went ahead and bobbed off the tang and re-shaped it.....
I want the overall length and the distance between the front and rear bedding screws, and their locations, to be exactly the same as a XP-22.
This so it will fit existing stocks, including a modified factory stock should I ever get up the nerve to modify another......way too much work..
Although, man, do they ever work........
Your friend, BC
_____________________________________
I've got a long .125" drill bit passing through the rear trigger pin hole of each action......
_____________________________
_____________________________
I shaped the tang slightly different from the XP, and it fits the factory stock quite well shaped like this....
____________________________
___________________________________________
________________________________
If I decided to go with a manual re-set trigger I'll have to mill the right side of the tang to the shape of the XP's.....
But I'm still thinking............I like the looks of it like it is.......
CYA friends:
I've been working on my 40-X pistol some today...
I went ahead and bobbed off the tang and re-shaped it.....
I want the overall length and the distance between the front and rear bedding screws, and their locations, to be exactly the same as a XP-22.
This so it will fit existing stocks, including a modified factory stock should I ever get up the nerve to modify another......way too much work..
Although, man, do they ever work........
Your friend, BC
_____________________________________
I've got a long .125" drill bit passing through the rear trigger pin hole of each action......
_____________________________
_____________________________
I shaped the tang slightly different from the XP, and it fits the factory stock quite well shaped like this....
____________________________
___________________________________________
________________________________
If I decided to go with a manual re-set trigger I'll have to mill the right side of the tang to the shape of the XP's.....
But I'm still thinking............I like the looks of it like it is.......
Last edited: